This tutorial shows how to fit the Chain Ring Assembly into the XE-1
1. Work Instruction – Fit Chain Ring Assembly
TOOLS REQUIRED
| ID | Description | Task |
| JP00060 | TOOL, LOCKING RING, ISIS, WITH CORE, STD | Remove Chain Ring Spider Lock Nut (Ring) |
| 19 mm Ring or Open-Ended Wrench | Remove Chain Ring Spider Lock Nut (Ring) | |
| Generic round bar or Cassette Removal Tool with long chain whip. | Hold Chain Ring to prevent it from rotating when tightening Chain Ring Spider Lock Nut |
|
|
INFORMATION: Inspect the Chain Ring for excessive wear. For the Chain Ring, Chain, and Sprocket to work well together all components must have a similar pitch (state of wear). |
1.1 Place the Chain Ring Assembly onto the Motor Drive Shaft Spline.
1.2 Place the Lock Nut onto the Motor Drive Shaft and fasten by rotating the round Lock Nut anti-clockwise. [Tools: TOOL, LOCKING RING, ISIS, WITH CORE, STD].
|
|
INFORMATION: Screw the tool core into the axle, place the main tool body with pins over the core and to engage the 8 Lock Nut holes. Using a 19 mm wrench, rotate the tool and Lock Nut anti-clockwise to fasten. Use a round bar or Cassette Removal Tool with long chain whip to stop the Chain Ring from spinning while tightening. |