Chain Drive
      Back to home
      1. Help Desk
      2. TECHNICAL WORK INSTRUCTIONS
      3. Chain Drive

      REMOVE CHAIN TENSIONER BRACKET WITH PULLEY

      This tutorial shows how to remove the Chain Tensioner Bracket with Pulley from the XE-1

      1. Remove Chain Tensioner Bracket with Pulley

      TOOLS REQUIRED

      ID Description Task
        M5 Hex Key

      Loosen M6 Cap Screws

       

      1.1 Loosen and remove 35 mm Aluminium Cap Screws with large 18 mm Washers [M5 Hex]

      WI0035_1.1

      INFO INFORMATION: Note that Tef-Gel lubricant rather than Loctite thread locker is used on the screws in this location to allow for the screws to be loosened and fastened regularly when adjusting Chain tension.
      The M6 Chain Tensioner Bracket screws have a length of 35 mm and must not be replaced with shorter length screws. Using shorter screws may cause damage to the threads in the XE-1 Frame.

      1.2 Remove Chain Tensioner Bracket with Pulley Assembly

      WI0035_1.2